Part Number Hot Search : 
LP156 V150K10 DAC080 NCP662 IRFP914 HEF405 2SC1448 005160
Product Description
Full Text Search
 

To Download GS-R4840NV Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 GS-R4840NV
36 W NEGATIVE SWITCHING REGULATOR
Type GS-R4840NV Vin -40 to -60 V Vout -22 to -60 V Iout -600 mA
FEATURES Digital input for voltage selection Short-circuit protection Overvoltage protection Thermal protection Softstart Fault signal indication output High efficiency (>80%)
DESCRIPTION The GS-R4840NV is a negative input, negative output switching voltage regulator that provides up to 36W output power without input-output isolation.
The output voltage is programmable by input logic signals that allow 64 steps (6 bit) of regulated output, from -22 to -60V.
ELECTRICAL CHARACTERISTICS (Tamb = 25C unless otherwise specified)
Symbol Vi Vir Vo Vor Voov Io Iol Iosc fs Rth Tcop T stg Parameter Input Voltage Input Ripple Voltage Output Voltage Output Ripple Voltage Output Overvoltage Protection Output Current Current Limit Output Average Short Circ. Current Switching Frequency Efficiency Thermal Resistance Operating Case Temperature Range Storage Temperature Range Vi = -48V Vo = -48V Case to Ambient 0 -20 Io = -600mA 80 Test Conditions Vo = -22 to -60V Io = -10 to -600mA Vi = -40 to -60V Vi = -40 to -60V Vo = -22 to -60V Io = -600mA Vi = -40 to -60V Io = -10 to -600mA Vi = -40 to -60V Vo = -22 to -60V Vi = -40 to -60V Overload Condition Vi = -40 to -60V 100 82 4 +85 +105 Vo+5% -10 Io = -600mA Io = -10 to -600mA -22 4 Min -40 Typ -48 Max -60 20 -60 10 Vo+10% -600 -900 -80 Unit V mVpp V mVpp V mA mA mA kHz % C/W C C 1/3
December 1993
GS-R4840NV
CONNECTION DIAGRAM AND MECHANICAL DATA
Package F. Dimensions in mm. (inches) PIN DESCRIPTION
Pin 1 2 Function -Vin Inhibit/ Enable 3 4 5 6 7 8 9 10 11 12 13 14 GND IN +5V IN DB0 DB1 DB2 DB3 DB4 DB5 CS WR -Vout FAULT Negative input voltage. Remote Inhibit/Enable logically compatible with CMOS or open collector TTL. The converter is OFF (Inhibit) when this pin is unconnected or the voltage applied is in the range of 2 to 5V (referred to GND). The converter is ON (Enable) for a control voltage in the range of 0 to 0.8V maximum. Return for input voltage source and +5V logic supply voltage. Internally connected to pin 15. +5V logic supply voltage. Maximum voltage must not exceed 7V. Data bit 0 (LSB). Data bit 1. Data bit 2. Data bit 3. Data bit 4. Data bit 5 (MSB). Chip select. An active low input control which is the device enable input terminal. Write control. An active low control which enables the microprocessor to write data to the DAC. Negative output voltage. FAULT indication output (referred to GND). The FAULT signal is high (TTL compatible level) when: - the INHIBIT is ON (high) - an output overload is present (Vo < 18V typ.) - an overtemperature is present - an overvoltage is present (Vo > Vo+5%) Return for output voltage source. Internally connected to pin 3. Description
15
GND OUT
Note: Case internally connected to Ground.
2/3
GS-R4840NV
USER NOTES Digital Information The GS-R4840NV accepts 6 bit binary at the data inputs DB0 to DB5. Data are transferred when CS is low and during the rising edge of WR signal.
tDS and tDH have to be 100ns and 50ns minimum respectively (see fig. 1).
Figure 1 - Signals Timing.
Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specification mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of SGS-THOMSON Microelectronics. (c) 1994 SGS-THOMSON Microelectronics - All Rights Reserved SGS-THOMSON Microelectronics GROUP OF COMPANIES Australia - Brazil - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco - The Netherlands Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A.
3/3


▲Up To Search▲   

 
Price & Availability of GS-R4840NV

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X